Playing And Charging Your Iphone/Ipod; Using The Line-In Jack - iHome iP37 Owner's Manual

1. Place proper insert for your iPhone/iPod (see insert table on page 1) in Dock, then gently dock iPhone/iPod. When docked
and connected to AC power, the iPhone/iPod will charge until fully charged. The unit will not charge iPhone or iPod
when operating on batteries.The iPhone/iPod will not overcharge.
2. Press the Button to play iPhone/iPod and the button will light up to show iP37 is on.
3. Press the + or – Button to adjust unit volume.
4. To switch off the unit, press the
1. Plug one end of an audio patch cord (available at www.ihomeaudio.com) into the headphone or line-out jack on your
audio device and the other end of the patch cord into the iP37 Line-in Jack.
2. Press the Button to turn the unit on and begin playback on your external audio device.The button will light up to show
iP37 is on.
3. Press the + or – Button Volume to adjust the volume. You may need to adjust your device's volume too.
4. To switch off the unit, just press the
NOTE: Do not connect and play an audio device to the line-in jack while playing an iPhone or iPod in the dock or you will
hear both sound sources at once.
Playing and Charging your iPhone or iPod
Button once more. It will switch off both iP37 and your iPhone/iPod.

Using the Line-in Jack

Button again. Remember to switch off your device too.
4