Clutch Lever; Shift Pedal - Yamaha FZS10A Owner's Manual

Start switch " "
Push this switch to crank the engine
with the starter. See page 6-1 for start-
ing instructions prior to starting the en-
gine.
The engine trouble warning light will
come on when the key is turned to "ON"
and the start switch is pushed, but this
does not indicate a malfunction.
Hazard switch " "
With the key in the "ON" position, use
this switch to turn on the hazard lights
(simultaneous flashing of all turn signal
lights).
The hazard lights are used in case of
an emergency or to warn other drivers
when your vehicle is stopped where it
might be a traffic hazard.
NOTICE
Do not use the hazard lights for an
extended length of time with the en-
gine not running, otherwise the bat-
tery may discharge.
INSTRUMENT AND CONTROL FUNCTIONS
EAU12711

Clutch lever

EAU41700
1. Clutch lever
EAU12765
The clutch lever is located at the left
handlebar grip. To disengage the
clutch, pull the lever toward the handle-
bar grip. To engage the clutch, release
the lever. The lever should be pulled
rapidly and released slowly for smooth
clutch operation.
The clutch lever is equipped with a
clutch switch, which is part of the igni-
ECA10061 tion circuit cut-off system. (See page
4-22.)
EAU12820

Shift pedal

1. Shift pedal
The shift pedal is located on the left
side of the motorcycle and is used in
combination with the clutch lever when
shifting the gears of the 6-speed con-
stant-mesh transmission equipped on
this motorcycle.
4-10
EAU12871
4