Troubleshooting - McCulloch MC1230 Owner's Manual

PROBLEM
Unit fails to heat up.
Steam output is weak or
intermittent.
Excessive amount of water in
steam.
NOTE: Unit produces wet steam
– it is normal for steam to
contain some amount of water.
Accessories do not stay firmly
connected to Steam Nozzle.
14 | ENGLISH

Troubleshooting

POSSIBLE CAUSE
Unit is not plugged in. Household
circuit breaker / ground fault inter-
rupter has tripped or blown a fuse.
Unit is damaged or otherwise in
need of repair.
Boiler is empty.
Mineral build-up in unit.
Water level in Boiler is running
low.
Mineral build-up in unit.
Water condensation in Extension
Hose.
Boiler has been
overfilled.
Accessories not properly installed.
SOLUTION
Plug power cord into electrical outlet.
Reset circuit breaker / ground
fault interrupter, or replace fuse.
If you need assistance, contact a
licensed electrician.
Immediately cease usage and
unplug. Contact Consumer
Service for further assistance
(see Page 16 for details).
Refer to Filling The Boiler proce-
dure on Page 11.
Refer to Mineral Build-up section
on Page 13 for cleaning procedure.
Refer to Filling The Boiler proce-
dure on Page 11.
Refer to Mineral Build-up section
on Page 13 for cleaning procedure.
Point nozzle towards sink, tub or
ground and shake while pressing
Steam Trigger. Continue until
excess water is released.
Filling Boiler with more than 6 oz.
(177 ml.) of water interferes with
steam production, resulting in
water condensation in steam.
Always use included Fill Cup to fill
unit with correct amount of water.
(see Page 11 for details)
Check to make sure that acces-
sories are properly connected, per
procedures on Pages 8-9.