General Operation - McCulloch MC1230 Owner's Manual

GENERAL OPERATION

NOTE: Be sure that Boiler has been filled and that all desired accessories are connected
before following these steps.
1. For first time use, remove protective plastic cover from electrical plug. Plug power cord into a
electrical outlet.
2. Press On/Off Switch to "On" position. Steam Indicator Light will illuminate Red. Once unit is
ready to steam, Steam Indicator Light will turn Green. During use, the light may turn Red, indi-
cating the steamer is recovering the necessary pressure. Unit can be used at a lower pressure.
3. Direct Nozzle (and any connected accessory) towards surface you desire to steam, and press
Steam Trigger. To sanitize surfaces, point Nozzle, press Trigger and hold approximately 1/2 inch
from surface for at least 5 seconds. This will insure that you have killed germs and bacteria.
CAUTION: Always be sure that Nozzle and any accessory are pointed in a safe direction
(away from yourself, other people, pets, and plants) before pressing Steam Trigger.
4. Keep Steam Trigger pressed for a continuous flow of steam. You may also hold the Steam Trig-
ger, then push the Steam Trigger Lock to lock it down. This will allow a continuous flow of steam
without need of holding the Steam Trigger down manually.
5. Using a back-and-forth motion over the area you are steaming will further enhance the clean-
ing process. Wipe steamed areas with a clean cloth to remove loosened dirt and grime. Wip-
ing the area while it is still wet is recommended, but use caution when wiping surfaces such as metal
that may still be hot.
6. Once steaming tasks are complete, turn the unit "Off" and unplug. Follow steps under Proper
Storage procedure on Page 13 of this manual.
12 | ENGLISH
Using Your Handheld Steam Cleaner