Chapter 2 Installing the VOI-8000
This chapter gives information on how to install the VOI-8000.
2.1
Network Requirements
For the VOI-8000 to successfully operate in your network, your network must meet the
following requirements:
1.
A working 10/100 Base-T Ethernet. The VOI-8000 connects to Internet via an Ethernet
LAN.
2.
IP network that supports gateway, and subnet mask. You'll need static IP address to
assign the VOI-8000.
2.2
Installing the VOI-8000
The VOI-8000 can be used in a desktop configuration or mounted in a standard 19-inch rack
enclosure. Ensure that the VOI-8000 is placed in a clean, well-ventilated, and vibration-free
environment.
When the VOI-8000 is placed on a desktop, be certain that the unit is placed on a sturdy, flat
surface, near a grounded power outlet. At least three inches of clearance must be provided
on both sides of the VOI-8000 for well ventilation.
2.3
Installing the telephony interface module
The VOI-8000 allows the installation of up to two TIMs. The following steps illustrate how
to install a TIM:
Unfasten the two screws holding the cover of the TIM slot A on the rear panel.
1.
Remove the cover.
2.
Before proceeding further, wear a grounded wrist strap.
4.
Remove the TIM from its static-free bag. Holding the module such that the metal
5.
bracket is facing toward you.
Carefully align the edge of the module facing away from you with the slide-in
6.
guide inside the VOI-8000, and insert the module into the slide-in slot until it is
fully sited.
Fasten the screws on the module.
7.
Repeat step 1 through 6 for slot B if you have two TIMs. If you have only a
8.
single TIM, be certain to install it in slot A, otherwise, the VOI-8000 won't
function.
4
VOI-8000 User's Guide
Overview