Power Switch Cover; Connector Cover - Epson TM-T88IV Technical Reference Manual

1.4.4 Power Switch Cover

Install the power switch cover that comes with the TM-T88IV onto the printer to prevent
inadvertent changing of the power switch, to prevent tampering, and to improve the appearance
of the printer.
To reset the TM printer when the power switch cover is installed, insert a long, thin object (such
as the end of a paper clip) into the hole in the power switch cover and press the power switch.
Note:
If an accident occurs with the power switch cover attached, unplug the power cord immediately.
Continued use may cause fire or shock.

1.4.5 Connector Cover

Use the following method to attach the connector cover.
1.4.5.1 Attaching and Removing the Connector Cover
These instructions apply if a connector cover is packed with your printer to protect your cables.
To attach it, follow the steps below:
1. First, connect all the cables. The connector cover has three possible cable exits: on the right,
left, and back.
2. Position the two hooks on the connector cover so that they hook the printer case, as shown in
illustration.
Rev. A
TM-T88IV Technical Reference Guide
Power Switch Cover
The two hooks
Product Overview 1-9