Advertisement
If you want to program Channel 3 after programming Channel 1, release the Valet/Program switch, press it twice
and release it to advance to Channel 3. Then press it once more and H H O O L L D D it. The horn will honk three times (if
connected) and the LED will flash three times to confirm it is ready to receive the code from the transmitter.
L L e e a a r r n n R R o o u u t t i i n n e e w w i i l l l l b b e e e e x x i i t t e e d d i i f f : :
■ Door is closed.
■ Ignition is turned off.
■ Program switch is pressed too many times.
■ More than 15 seconds between steps.
t t r r a a n n s s m m i i t t t t e e r r c c o o n n f f i i g g u u r r a a t t i i o o n n s s
The transmitters can be programmed with the standard or single button arm/disarm configurations by using the
Auto Learn functions in the Transmitter/Receiver Learn Routine.
s s t t a a n n d d a a r r d d c c o o n n f f i i g g u u r r a a t t i i o o n n
A remote that uses the standard configuration operates similarly to many factory keyless entry remotes. A stan-
dard configuration transmitter allows arming, disarming, and Panic Mode activation with separate buttons. When
programmed for standard configuration, the transmitter buttons are assigned to the following functions:
© 2005 Directed Electronics—all rights reserved
.................................operates ...........................Arm/Lock,
.................................operates ...........................Disarm/Unlock/
.................................operates ...........................Remote start
.................................operates ...........................Channel 2—trunk
and
................operate............................Timer Mode
and
................operate ..........................Short Run/Turbo
and
................operate............................Channel 4
Panic ON/Panic OFF
panic off
release
timer
3 3 7 7
Advertisement
