Sennheiser Comfort calls Instruction Manual page 19

Putting the headset system into operation
²
¶
18
Press either the LINK button
»
button on the base station.
A wireless link is established between the headset and the base
¿
station, the LINK LED
blue.
¿
Lift the handset (if a handset lifter is connected, it automatically lifts
the handset).
The system is correctly connected if you can hear a clear dial tone and
if the other party can hear you at a comfortable level. If the audio
signal/dial tone is disturbed, adjust the audio signal (see next section).
If the other party cannot hear you well, adjust the microphone
sensitivity (see below).
Adjusting the audio signal/dial tone
Set the ABC switch to A
clear dial tone in the headset.
Adjusting the microphone sensitivity
By default, the microphone volume control
and position 5. This setting is suitable for most telephones and your voice
gets reproduced at a good volume. To change the volume, adjust the
microphone volume control accordingly.
The microphone volume control
sensitivity in Phone
Make a call to someone who will help you find the correct sensitivity
setting for your microphone (see page 25).
Turn the microphone volume control
at a comfortable level.
on the headset or the PHONE
lights up blue and the HEADSET LED
»
4
(default setting), B or C so that you can hear a
¶
is set to between position
¶
only adjusts the microphone
mode.
¶
so that the other party can hear
flashes
3
4