Setting Power Saving Functions; Setting Up A Wireless Lan - Sony PDW-F800 Operation Manual

Setting power saving functions

You can limit the function of some output
connectors to save power consumption.
(How to select an item in the menu screen: Turn
the MENU knob to move b to the desired item.)
1
Display the POWER SAVE page of the
OPERATION menu, and press the
MENU knob.
For details on menu operations, see "Basic
menu operations" on page 206.
2
Select the desired item, and press the
MENU knob.
You can set the following items on the
POWER SAVE page.
Item Description
ETHERNET/ Enables or disables the
network connector and USB
USB
connector.
a) Enables or disables the
i.LINK(FAM)
i.LINK connector (FAM
function).
REC AUDIO Puts the AUDIO OUT
OUT connectors in EE or SAVE
mode.
TEST OUT Switches the TEST OUT
SAVE connector power saving
function on and off.
ON: No signals are output if
OFF: Signals are always
Wi-Fi Enables or disables the
wireless LAN function.
a) The unit must be powered off and on again to
enable changes to this setting.
3
Turn the MENU knob to select the
desired setting, and press the MENU
knob.
4
Repeat steps 2 and 3 until you have set
all of the desired items.
a cable is not
connected.
output, regardless of
whether a cable is
connected.

Setting up a wireless LAN

You can install the optional CBK-WA01 Wi-Fi
adapter in this unit, and set up a wireless LAN as
explained in this section.
When you connect this unit to a computer over a
network, you can make the settings explained here
from a Web menu. For details, refer to the operation
manual supplied with the optional CBK-WA01 Wi-Fi
adapter.
Notes
• The CBKZ-UPG01 Software Upgrade Key must be
installed to make these settings.
• For information about connecting to a wireless LAN,
refer to the operation manual supplied with the
optional CBK-WA01 Wi-Fi adapter.
• Even when the optional CBK-WA01 Wi-Fi adapter is
installed in this unit, the message "NO Wi-Fi
ADAPTER!" may appear if you attempt to set up a
wireless LAN immediately after powering the unit on.
If this occurs, wait for a while and try again.
• If the message "IEEE802.1X IS ENABLED!" appears
when you change the settings, execute NET CFG
RESET on the NETWORK 2 page of the
MAINTENANCE menu and then try again.
• The proxy data recording function is disabled
automatically whenever you enable the wireless LAN
connection function.
Before starting, set ETHERNET/USB and Wi-Fi
on the POWER SAVE page of the OPERATION
menu to "ENABL".
(How to select an item in the menu screen: Turn
the MENU knob to move b to the desired item.)
1
Display the Wi-Fi page of the
MAINTENANCE menu, and then press
the MENU knob.
See "Basic menu operations" (page 206) for
more information about menu operations.
M26 Wi-Fi
Wi-Fi SETUP
Wi-Fi STATUS :
WIRELESS MODE:
SSID: (unknown)
NETWORK TYPE :
CH
AUTH
ENCRYPTION
2
Select "Wi-Fi SETUP" and then press
the MENU knob.
Adjustments and Settings from Menus
TOP
: EXEC
[-----]
802.11b
INFRA
: 1
: OPEN
: DISABLE
225