Attaching Seat Back/Seat Pad; Attaching Music Center; Adjusting Seat Height - Graco Activity Walker Instructions Manual

Instructions
EN
Attaching seat back
• Open the walker by holding onto the base
with one hand while lifting the tray with the
other hand.
Push seat back down into position snapping
1
seat back hooks into both lower slots.
Push seat back forward to lock front hooks.
2
NOTE: Make sure seat back is attached to
frame and cannot be pulled out.
Attaching seat pad
Place seat pad into walker and insert the
3
8 round tabs into slots located around the
seating area.
• Slide tabs through holes.
• Turn walker upside-down.
Pull tabs and align into grooves. You may
4
have to push tabs from top of walker to
properly fasten.
CAUTION: DO NOT use walker if all tabs
are not secured properly, otherwise child|
may fall through walker.

Attaching music center

Place music center on walker tray.
5
• Clip the brackets (on both sides) under the
lower edge of the walker tray rim.
NOTE: To insert/replace batteries, remove
tray and battery cover (by unscrewing
single screw). Fit batteries as set out and
replace battery cover (and screw).
This product requires 2 AA (LR6) 1.5 volt
batteries. (Batteries not included)
WARNING: DO NOT lift walker by music
center or tray.

Adjusting seat height

• Hold base of walker stationery.
While lifting the tray up, pull lever forward and
6
adjust tray.
• Raise or lower seat into one of three positions.
NOTE: tray must be lifted before lever can
be moved.
TO FOLD walker, lower the seat to the lowest
7
position.
7