Sony RDR-HX730 Operating Instructions Manual page 95

Recording/Timer recording/
Editing
The channel cannot be changed from the
channel you are recording.
, Set the TV's input source to "TV."
Recording does not start immediately
after you press z REC.
, Operate the recorder only after "LOAD,"
"FORMAT," or "INFOWRITE" disappears
from the front panel display.
Nothing was recorded even though you set
the timer setting correctly.
, There was a power failure during recording.
, The recorder's internal clock stopped due to
a power failure that lasted for more than 1
hour. Reset the clock (page 81).
, The channel was disabled after the timer
recording was set. See "Tuner Preset" on
page 80.
, Disconnect the AC power cord from the AC
outlet, and connect it again.
, The program contains copy protection
signals that restrict copying.
, The timer setting overlapped another
setting that was set later.
, There is no DVD inside the recorder.
, There is not enough disc space for the
recording.
, A separate recording was in the process of
being made without the use of the timer
(page 50).
, The recorder was in the process of dubbing
(HDDyDVD).
, The recorder was in the process of DV/
Digital8 Dubbing.
Recording does not stop immediately
after you press x REC STOP.
, It will take a few seconds for the recorder to
input disc data before recording can stop.
Recording does not stop after you press
x STOP.
, Press x REC STOP.
Timer recording is not complete or did not
start from the beginning.
, There was a power failure during recording.
If the power recovers when there is a timer
recording, the recorder resumes recording.
Should the power failure continue for more
than 1 hour, reset the clock (page 81).
, Disc space was not enough.
Contents previously recorded were
erased.
, Data that is not playable on this recorder but
was recorded on a DVD with a PC will be
erased from the disc when the disc is
inserted.
, "Auto Title Erase" of the "Timer Settings"
in the "Recording" setup is set to "On"
(page 87).
Recording from the equipment
with a timer
Nothing was recorded even though you set
the Synchro-Rec setting correctly.
, You forgot to turn off the connected
equipment. Turn off the connected
equipment and set the recorder to Synchro-
Rec standby mode (page 50).
, The recorder was not set to the Synchro-
Recording standby mode. Press
c z SYNCHRO REC to have the recorder
stand by for recording. Make sure the
SYNCHRO REC indicator lights up on the
front panel (page 50).
, The equipment is not connected to the LINE
IN 1 jacks of the recorder.
, The recorder is connected to the TV output
jack of the connected equipment.
Synchro-Recording does not complete.
, The timer setting for the connected
equipment overlapped the recorder's timer
setting (page 51).
, There was a power failure during the
recording.
95
,continued