Related Manuals for Seagate Barracuda 7200.14
Summary of Contents for Seagate Barracuda 7200.14
- Page 1 Product Manual Seagate Desktop HDD ® Formerly Barracuda 7200.14 ST3000DM001 ST750DM003 ST2000DM001 ST500DM002 ST1500DM003 ST320DM000 ST1000DM003 ST250DM000 Gen 14 100686584 Rev. J May 2014...
- Page 2 Technology LLC or one of its affiliated companies in the United States and/or other countries. All other trademarks or registered trademarks are the property of their respective owners. No part of this publication may be reproduced in any form without written permission of Seagate Technology LLC. Call 877-PUB-TEK1(877-782-8351) to request permission.
-
Page 3: Table Of Contents
Seagate Technology Support Services ........ - Page 4 Mounting dimensions (1-disk: 250GB to 1TB models) ........21 Seagate Desktop HDD Product Manual, Rev. J...
-
Page 5: Seagate Technology Support Services
Authorized Service Centers For information regarding Warranty Support, visit: http://www.seagate.com/support/warranty-and-replacements/ For information regarding data recovery services, visit: http://www.seagate.com/services-software/data-recovery-services/ For Seagate OEM and Distribution partner portal, visit: http://www.seagate.com/partners For Seagate reseller portal, visit: http://www.seagate.com/partners/my-spp-dashboard/ Seagate Desktop HDD Product Manual, Rev. J... -
Page 6: Introduction
• Seagate AcuTrac™ servo technology delivers dependable performance, even with hard drive track widths of only 75 nanometers. • Seagate OptiCache™ technology boosts overall performance by as much as 45% over the previous generation. • Seagate SmartAlign™ technology provides a simple, transparent migration to Advanced Format 4K sectors •... -
Page 7: About The Sata Interface
SATA ports are represented to host software as a Device 0 (master) and Device 1 (slave) accessed at the same set of host Note bus addresses. A host adapter that emulates a master/slave environment manages two sets of shadow registers. This is not a typical SATA environment. Seagate Desktop HDD Product Manual, Rev. J... -
Page 8: Drive Specifications
Average seek, write (typical) <9.5ms typical Startup current 12V 2.0A or 2.8A 2.0A 5V: ±5% Voltage tolerance (including noise) 12V: +10% / -7.5% 0° to 60°C (operating) Ambient temperature –40° to 70°C (non-operating) Seagate Desktop HDD Product Manual, Rev. J... - Page 9 ** One GB equals one billion bytes and 1TB equals one trillion bytes when referring to hard drive capacity. Accessible capacity may vary depending on operating environment and formatting. * ** During periods of drive idle, some offline activity may occur according to the S.M.A.R.T. specification, which may increase acoustic and power to operational levels. Seagate Desktop HDD Product Manual, Rev. J...
- Page 10 Operational shock (max) 70 Gs at 2ms Non-operational shock (max) 350 Gs at 2ms 2Hz to 22Hz: 0.25 Gs, Limited displacement Vibration, operating 22Hz to 350Hz: 0.50 Gs 350Hz to 500Hz: 0.25 Gs Seagate Desktop HDD Product Manual, Rev. J...
-
Page 11: Formatted Capacityy
320GB 625,142,448 ST250DM000 250GB 488,397,168 *One GB equals one billion bytes and 1TB equals one trillion bytes when referring to hard drive capacity. Accessible capacity may vary depending on operating environment and formatting. Seagate Desktop HDD Product Manual, Rev. J... -
Page 12: Lba Mode
Maximum sustained data transfer rate, OD read (MB/s) 3TB, 2TB, 1.5TB, 1TB and 750GB models 500GB, 320GB, 250GB models Average data rate, read/write (MB/s) 3TB, 2TB, 1.5TB, 1TB and 750GB models 500GB, 320GB, 250GB models I/O data-transfer rate (MB/s max) Seagate Desktop HDD Product Manual, Rev. J... -
Page 13: Physical Characteristics
(such as track-to-track and average), are expected to meet the noted values. However, due to the manner in which Note these drives are formatted, benchmark tests that include command overhead or measure logical seeks may produce results that vary from these specifications. Seagate Desktop HDD Product Manual, Rev. J... -
Page 14: Start/Stop Times
Idle mode power is measured with the drive up to speed, with servo electronics active and with the heads in a random track location. • Standby mode During Standby mode, the drive accepts commands, but the drive is not spinning, and the servo and read/write electronics are in power-down mode. Seagate Desktop HDD Product Manual, Rev. J... - Page 15 Sleep 0.79 0.350 0.010 *During periods of drive idle, some offline activity may occur according to the S.M.A.R.T. specification, which may increase acoustic and power to operational levels. †5W IDLE with DIPLM Enabled Seagate Desktop HDD Product Manual, Rev. J...
-
Page 16: Conducted Noise
If the standby timer reaches zero before any drive activity is required, the drive makes a transition to Standby mode. In both Idle and Standby mode, the drive accepts all commands and returns to Active mode when disk access is necessary. Seagate Desktop HDD Product Manual, Rev. J... -
Page 17: Environmental Specifications
–304.8m to 3048m (–1000 ft. to 10,000+ ft.) Non-operating –304.8m to 12,192m (–1000 ft. to 40,000+ ft.) Maximum storage condition not to exceed 90 days at a wetbulb temperature of 32°C (example: 34°C / 90& RH) Note Seagate Desktop HDD Product Manual, Rev. J... -
Page 18: Shock
The maximum non-operating vibration levels that the drive may experience without incurring physical damage or degradation in performance when subsequently put into operation are specified below. 5Hz to 22Hz 3.0 Gs (Limited displacement) 22Hz to 350Hz 3.0 Gs 350Hz to 500Hz 3.0 Gs Seagate Desktop HDD Product Manual, Rev. J... -
Page 19: Acoustics
Seagate follows the ECMA-74 standards for measurement and identification of PDTs. An exception to this process is the use of the absolute threshold of hearing. Seagate uses this threshold curve (originated in ISO 389-7) to discern tone audibility and to compensate for the inaudible components of sound prior to computation of tone ratios according to Annex D of the ECMA-74 standards. -
Page 20: Warranty
EN 55022, Class B and the immunity levels are defined by EN 55024. Drives are tested in representative end-user systems. Although CE-marked Seagate drives comply with the directives when used in the test systems, we cannot guarantee that all systems will comply with the directives. The drive is designed for operation inside a properly designed enclosure, with properly shielded I/O cable (if necessary) and terminators on all unused I/O ports. -
Page 21: Fcc Verification
As a subassembly, no Federal Communications Commission verification or certification of the device is required. Seagate has tested this device in enclosures as described above to ensure that the total assembly (enclosure, disk drive, motherboard, power supply, etc.) does comply with the limits for a Class B computing device, pursuant to Subpart J, Part 15 of the FCC rules. -
Page 22: China Restriction Of Hazardous Substances (Rohs) Directive
The silver, copper, nickel and gold films used in Seagate products are especially sensitive to the presence of sulfide, chloride, and nitrate contaminants. Sulfur is found to be the most damaging. In addition, electronic components should never be exposed to condensing water on the surface of the printed circuit board assembly (PCBA) or exposed to an ambient relative humidity greater than 95%. -
Page 23: Configuring And Mounting The Drive
For installations which require cables, users can connect the drive as illustrated in Figure 1 Figure 1 Attaching SATA cabling Signal connector Power connector Signal cable Power cable Each cable is keyed to ensure correct orientation. Desktop HDD drives support latching SATA connectors. Seagate Desktop HDD Product Manual, Rev. J... -
Page 24: Drive Mounting
3 MINIMUM THREAD DEPTH 0.15 MAXIMUM FASTENER PENETRATION 2x 3.750 in 95.25 mm Drawings are for mounting hole reference only. Note PCBA show in pictorial only and can vary based on specific customer configurations. Seagate Desktop HDD Product Manual, Rev. J... -
Page 25: Figure 3 Mounting Dimensions (1-Disk: 250Gb To 1Tb Models)
3 MINIMUM THREAD DEPTH 0.15 MAXIMUM FASTENER PENETRATION 2x 3.750 in 95.25 mm Drawings are for mounting hole reference only. Note PCBA show in pictorial only and can vary based on specific customer configurations. Seagate Desktop HDD Product Manual, Rev. J... -
Page 26: Sata Interface
3. There are three power pins for each voltage. One pin from each voltage is used for pre-charge when installed in a blind-mate backplane configuration. • All used voltage pins (V ) must be terminated. Seagate Desktop HDD Product Manual, Rev. J... -
Page 27: Supported Ata Commands
Read Native Max Address Extended Read Sectors Read Sectors Extended Read Sectors Without Retries Read Verify Sectors Read Verify Sectors Extended Read Verify Sectors Without Retries Recalibrate Security Disable Password Security Erase Prepare Security Erase Unit Seagate Desktop HDD Product Manual, Rev. J... - Page 28 Write DMA Extended Write DMA FUA Extended Write DMA Without Retries Write Log Extended Write Multiple Write Multiple Extended Write Multiple FUA Extended Write Sectors Write Sectors Without Retries Write Sectors Extended Write Uncorrectable Seagate Desktop HDD Product Manual, Rev. J...
-
Page 29: Identify Device Command
Words 54–58, 64–70 and 88 are valid 0007 Number of current logical cylinders xxxx Number of current logical heads xxxx Number of current logical sectors per logical track xxxx 57–58 Current capacity in sectors xxxx Seagate Desktop HDD Product Manual, Rev. J... - Page 30 Ultra DMA support and current mode (see note following this table) xx7F Security erase time 0039 Enhanced security erase time 0039 Master password revision code FFFE Hardware reset value xxxx Automatic acoustic management 8080 95–99 ATA-reserved 0000 Seagate Desktop HDD Product Manual, Rev. J...
- Page 31 Media Card Pass Through Command feature set is supported. Streaming feature set is supported. GPL feature set is supported. WRITE DMA FUA EXT and WRITE MULTIPLE FUA EXT commands are supported. WRITE DMA QUEUED FUA EXT command is supported. Seagate Desktop HDD Product Manual, Rev. J...
- Page 32 Ultra DMA mode 2 is currently active. Ultra DMA mode 3 is currently active. Ultra DMA mode 4 is currently active. Ultra DMA mode 5 is currently active. Ultra DMA mode 6 is currently active. Seagate Desktop HDD Product Manual, Rev. J...
-
Page 33: Set Features Command
Disable use of SATA features Enable read look-ahead (read cache) feature (default). Report full capacity available At power-on, or after a hardware or software reset, the default values of the features are as indicated above. Note Seagate Desktop HDD Product Manual, Rev. J... -
Page 34: Commands
S.M.A.R.T. Enable Operations S.M.A.R.T. Disable Operations S.M.A.R.T. Return Status If an appropriate code is not written to the Features Register, the command is aborted and 0x 04 (abort) is written to Note the Error register. Seagate Desktop HDD Product Manual, Rev. J... - Page 35 Electromagnetic Compatibility control Regulation 16 Electromagnetic Compatibility Directive (2004/108/EC) 16 master/slave 3 Electromagnetic immunity 15 mounting 20 Electrostatic discharge 15 mounting screws 14 electrostatic discharge (ESD) 19 mounting the drive 19 EN 55022, Class B 16 Seagate Desktop HDD Product Manual, Rev. J...
- Page 36 13 temperature 9, 13 Reliability 16 temperature gradient 13 RF 15 timer 12 RMS read/write current 12 timers 12 RoHS 17, 18 track density 8 RRL 16 Track-to-track 9 Track-to-track seek time 9 Seagate Desktop HDD Product Manual, Rev. J...
- Page 37 Write DMA Without Retries 24 Write Log Extended 24 Write Multiple 24 Write Multiple Extended 24 Write Multiple FUA Extended 24 Write Sectors 24 Write Sectors Extended 24 Write Sectors Without Retries 24 Seagate Desktop HDD Product Manual, Rev. J...
- Page 38 ASIA/PACIFIC Seagate Singapore International Headquarters Pte. Ltd. 7000 Ang Mo Kio Avenue 5, Singapore 569877, 65-6485-3888 EUROPE, MIDDLE EAST AND AFRICA Seagate Technology SAS 16-18 rue du Dôme, 92100 Boulogne-Billancourt, France, 33 1-4186 10 00 Publication Number: 100686584, Rev. J...