Pontiac G6 2009 User Manual page 3

Hide thumbs Also See for G6 2009:
Table of Contents

Advertisement

Starting the Vehicle
1. Aim the RKE transmitter at the
vehicle. (Transmitter range is within
approximately 200 feet of the
vehicle.)
2. Press and release the
button on the transmitter.
3. Immediately press and hold the
(Remote Start) button for about four
seconds. When the vehicle starts,
the parking lamps will light and
remain on while the engine is
running. The engine will continue
running for 10 minutes.
4. Repeat these steps for a 10-minute
time extension. Only two consecu-
tive remote starts are allowed.
When you enter the vehicle after a
remote start, the ignition must be
turned to the On position before driving.
Note: The Remote Vehicle Start feature
will not operate if the key is in the ignition,
the hood is open, or the Check Engine
light is illuminated on the instrument
panel cluster.
REMOTE KEYLESS ENTRY SYSTEM
Canceling a Remote Start
To turn off the engine instead of driving
after a remote start, do any of the
following:
• Press and hold the
Start) button until the parking lamps
turn off.
• Press and release the Hazard
Warning Flashers button. Press it
again to turn off the flashers.
• Turn the key in the ignition switch to
the On position and then off.
Note: Instructions for the Remote Vehicle
Start System are provided on a tag that
(Lock)
can be attached to your vehicle's key
chain.
See Section 2 of your Owner Manual.
(Remote
3

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents