NordicTrack COMMERCIAL 1500 User Manual page 10

If you purchase the optional chest pulse sensor (see page 21), follow the steps below to install the re-
ceiver included with the chest pulse sensor.
1. Make sure that the power cord is unplugged.
Remove the indicated #8 x 3/4" Screws (4) from
the Pulse Receiver Cover (70) on the back of the
console assembly.
2. Next, hold the receiver so the antenna is ori-
ented as shown. Attach the receiver to the
Pulse Receiver Cover (70) with the two included
small screws.
3. Connect the wire on the receiver to the wire ex-
tending from the console assembly. Make sure
that no wires are pinched. Slide the tab on the
Pulse Receiver Cover (70) into the indicated hole
in the console assembly. Reattach the Pulse
Receiver Cover to the console assembly with the
two #8 x 3/4" Screws (4). Discard the other wires
included with the receiver.
1
Console
Assembly
2
Antenna
3
Hole
Console
Tab
Assembly
10
70
4
Small Screws
Receiver
70
Wires
70
4