Carrier Infinity SYSTXCCITW01 Installation Instructions Manual page 17

ELECTRICAL OPERATION HAZARD
Failure to follow this warning could result in personal injury
or death.
Before installing, modifying, or servicing system, the main
electrical disconnect switch must be in the OFF position. There
may be more than 1 disconnect switch. Lock out and tag
switch with a suitable warning label.
Turn off all power to equipment.
S
If an existing Infinityr Control or other control is being replaced:
S
Remove existing control from wall.
d
Disconnect wires from existing control.
d
Discard or recycle old control.
d
NOTE: Mercury is a hazardous waste, if existing control contains any
S
mercury, it MUST be disposed of properly. The Infinity Touch Control
does not contain mercury.
Select Infinity Control mounting plastic (backplate and decorative backplate if
S
desired).
Route wires through large hole in mounting plastic. Level rear plastic against
S
wall (for aesthetic value only; Infinity Touch Control need not be level to
operate properly) and mark wall through two mounting holes.
Drill two 3/16- - in (4.8 mm) mounting holes in wall where marked.
S
Secure mounting plastic to wall using two screws and anchors provided.
S
WARNING
!
9