IBM 8260 Installation Instructions Manual page 23

Installation Instructions
2.8 .1.4 Migration of PEER GROUP 3 - HUB d
--- ATM ADDRESS SETTING ---------------------------------------------------
After having completed the swap, the ATM address has been migrated to the Node-0
ATM address, but the PNNI Summary Address was set to a default value. So you need
to enter the old ATM address again, with a new selector, by issuing the following
command :
o HUBd>set pnni node_0 atm_address:
39.99.99.99.99.99.99.00.00.88.88.03.01.D0.E0.20.15.16.17.19
o HUBd>SHOW FUTURE_PNNI NODE_0
Check your new ATM address.
o HUBd>COMMIT PNNI, the 8260 will be reset
The telnet session if any is broken.
Login as ADMINISTRATOR on the 8260 console.
o HUBd>SHOW PNNI NODE_0
Check your ATM address. It will display information about : LEVEL
ID, PEERGROUP ID, NODE ID.
--- PORT SETTING ----------------------------------------------------------
After having completed the swap, your NNI port will become a disabled IISP port, so
you need to re-enable it :
Enable your old NNI port (now IISP) as IISP
Because in the example, the VPC between hubd and hubc is ZERO, you can define the
port 6.1 as IISP:
HUBd> SET PORT 6.1 ENABLE IISP
--- VIRTUAL PATH CHANNELS SETTING (VPCS) : --------------------------------
No VPCs links need to be defined
PN : 26L0227 EC : F34705 June 17 1998
Copyright IBM Corp. 1998
Page 23