IBM 8260 Installation Instructions Manual page 13

Installation Instructions
2.7 Step 7: Check the new levels of codes :
1 Login as ADMINISTRATOR on the active A-CPSW console
2 The following table lists the microcode and FPGA versions that must be displayed at
completion of the upgrade. Use the following commands
Ÿ
SHOW DEVICE
Ÿ
SHOW MODULE n VERBOSE
Component
A-CPSW
WARNING
Because of the major differences of operations between PNNI-1 and SSI, all your PVC
are cleared, all logical links and static routes will be deleted.
Before performing any swap, record your network parameters for LOGICAL LINK,
STATIC ROUTE, ATM ADDRESS and VPC (record those information on a sheet of
paper):
Example for CLUSTER 1:
1. HUBb>SHOW LOGICAL_LINK ALL will display
PORT VPI ACN SIDE
3.1 3 02
2. HUBb>SHOW STATIC ROUTE will display :
INDEX ACN STATIC ROUTE
1 02
3. HUBb>SHOW DEVICE will display :
ATM ADDRESS: 39.99.99.99.99.99.99.00.00.77.77.01.02.00.00.82.60.01.02.00
4. HUBb>SHOW PVC ALL will display :
port id type
1.01
Active
PN : 26L0227
FPGA version
B52
MODE SIG TRAF BWITH STATUS INDEX
USER ENABLE 3.1
39.99.99.99.99.99.99.00.00.88.88.03
Vpi/Vci Port
4 PTM-PVC 1/50 4.01
EC : F34705 June 17 1998
Copyright IBM Corp. 1998
Flash EEPROM
version
v.3.1.9
ANY 85000 UP
Vpi/Vci Hnb Party
2/40 3
Boot EEPROM
Version
v.3.1.9
1
Role QOS Status
0 Primary BE
Page 13