Table of Contents
Advertisement
Cutting
Warning: this tool can cause serious injury if not used properly. Read this entire manual
before using. Note: The moveable Guard (#8A) must be in place at all times.
Note: verify that saw blade is securely tightened and both angle and height adjusting knobs
are tight.
1.
Secure rip fence or straight edge to the material to guide the saw on a straight path.
2.
Place the saw base (50A) on material to be cut. Align the front notch (right edge
aligns with saw blade) on the cut line.
3.
Pull the rear lock switch (safe button 45A) back with the middle finger and squeeze
the switch button (47A) with the index finger. Do this before the saw blade touches
the material.
4.
With the saw at full speed, move the saw slowly forward to complete the cut.
5.
When the cut is complete, release the power switch button (47A). Do not set the saw
down until the blade stops turning.
For this procedure, it may be helpful to look at the Reciprocating Saw assembly diagram
at the end of this manual.
1.
Remove the Battery from the housing.
2.
Install the Saw Blade by passing it through the Adjustable Pad (7B) and into the
Carrier (32B), between the Washer (2B) and the Carrier (32B), with teeth facing
downward. Tighten the hex bolt with the hex wrench to lock the blade in place.
The item numbers (in brackets) can be
found on the Reciprocating Saw
Assembly drawing and Parts List.
SKU 40056
40056 combo pack.p65
7
Reciprocating Saw Operation
Blade
Adjustable Pad (7B)
Page 7
10/10/03, 10:11 AM
Switch Button Lock (14B)
Trigger Switch (15B)
Battery (20B)
Advertisement
Table of Contents
