NordicTrack C 2500 User Manual page 9

8. Set the console assembly face down on a soft
surface to avoid scratching the console assem-
bly. Hold the Right Handrail (95) near the con-
sole assembly. Next, insert the console wire into
the large hole in the bottom of the Right
Handrail and out of the top as shown. If neces-
sary, use needlenose pliers to help pull the con-
sole wire out.
Attach the Right Handrail (95) and the Left
Handrail (not shown) with four #8 x 3/4" Screws
(1) (only one side is shown). Make sure that no
wires are pinched. Start all four Screws be-
fore tightening any of them; do not over-
tighten the Screws.
9. Tighten a 1/4" x 1 1/4" Bolt (5) with a 1/4" Star
Washer (33) into the bracket and Handrail
Crossbar (94) on each side of the console as-
sembly (only one side is shown).
Remove the wire tie from the console wire.
10. Remove the long tie from the Upright Wire (38).
Have a second person hold the console assem-
bly near the Right Upright (78) and Left Upright
(not shown). Connect the Upright Wire (38) to
the console wire. See the inset drawing. The
connectors should slide together easily and
snap into place. If they do not, turn one con-
nector and try again. IF THE CONNECTORS
ARE NOT CONNECTED PROPERLY, THE
CONSOLE MAY BE DAMAGED WHEN THE
POWER IS TURNED ON.
Set the console assembly on the Right Upright
(78) and Left Upright (not shown). Be careful
not to pinch the wires.
8
Console
Wire
95
Console
Assembly
9
Console
Wire
Console
Assembly
10
Console
Assembly
Console
Wire
78
9
1
1
Wire
Tie
5
33
Bracket
94
38
Console
Wire
Long
Tie
38