Running The Operating System Setup Program - IBM IntelliStation Z Pro 6221 Installation Manual

Approximately 20 seconds after the computer is connected to ac power, the
power-control button becomes active, and you can turn on the computer and start
the operating system by pressing the power-control button. The computer can also
be turned on in any of the following ways:
v If a power failure occurs while the computer is turned on, the computer will
v When you plug in your computer for the first time, Wake on LAN
v If your computer was previously turned on, it must be properly turned off for the

Running the operating system setup program

If you are starting your computer for the first time, the setup program runs
automatically when you start the computer. The program will prompt you to make
choices or type information. If you need more detailed information than is provided
in this Installation Guide, see your operating-system documentation.
Important:
1. After turning on your computer for the first time, you must complete the
2. The setup program might be slightly different from the one described in your
3. During the setup procedure, you must indicate that you accept the license
4. For Windows operating systems, the registration information will already be
You will need the following information to complete the setup program in Windows
operating systems:
v The documentation that comes with your computer.
v Network information from your network administrator, if your computer is being
v The printer model and port, if a printer is attached directly to your computer.
After the setup procedure finishes and the computer restarts, the desktop opens.
Your computer is ready for use.
restart automatically when power is restored.
computer.
Wake on LAN feature to turn on the computer.
operating system setup procedure before turning off your computer; otherwise,
unexpected results might occur.
operating-system manual. Some choices do not appear because they are
preset.
agreement.
displayed in the registration field. If the Product ID number is not already
displayed, you must type it. The Product ID is on a label attached to the
computer.
connected to a network.
®
can turn on the
Chapter 2. Installing the hardware
35