Step 3. Setting the SCSI ID
Refer to the following figure when setting the SCSI ID.
1 68-pin high density SCSI
connector
Note:
1. When setting the SCSI ID, use the jumpers that come with the tape drive.
2. If your enclosure uses a remote SCSI ID switch, remove the jumpers from the jumper
pins on the tape drive and connect the remote switch.
Find the jumper pin setting that corresponds to the SCSI ID number you choose;
then place jumper pins on the SCSI ID blocks as shown. You can use a pair of
flat-nose pliers to place the jumpers on the jumper pins.
1 SCSI ID
Step 4. Mounting the drive
Mount the tape drive; then attach the SCSI and power cables to it. If there is
insufficient working space to attach the connectors after mounting the drive, attach
the cables first. To mount the drive, follow these steps:
2 SCSI ID jumpers
2 Jumper block
Chapter 1. Installation and user's guide
3 Power connector
1-3