Hardware Identification Chart - Avari Fitness AVARI 2000R Recumbent Bike Owner's Manual

HARDWARE IDENTIFICATION CHART

This chart is provided to help identify the hardware used in the assembly process. Place the washers or
the ends of the bolts or screws on the circles to check for the correct diameter. Use the small scale to
check the length of the bolts and screws.
3/16" 1/4"
0 1/2 1
0 10 20 30
6 8
NOTICE: The length of all bolts and screws, except those with flat
heads, is measured from below the head to the end of the bolt
or screw. Flat head bolts and screws are measured from the
top of the head to the end of the bolt or screw.
After unpacking the unit, open the hardware bag and make sure that you have all the following items.
Some hardware may be already attached to the part.
5/16" 3/8"
1/2 2 1/2
40 50 60 70
10 12
Part No. and Description
48
49
44
45
46
50
53
54
55
56
57
58
64
65
61
63
66
67
1/2"
INCHES
3 1/2 4
80 90 100 110 120 130 140 150
MILLIMETERS
Bolt, Button Head (M8 x 1.25 x 25mm)
Bolt, Button Head (M8 x 1.25 x 20mm)
Bolt, Button Head (M8 x 1.25 x 75mm)
Bolt, Button Head (M8 x 1.25 x 60mm)
Bolt, Button Head (M8 x 1.25 x 56mm)
Carriage Bolt (M10 x 1.5 x 94mm)
Screw, Round Head (M5 x 0.8 x 10mm)
Screw, Round Head (M4 x 0.7 x 25mm)
Screw, Round Head (M4 x 30mm)
Screw, Round Head (M4 x 20mm)
Arc Washer (M10)
Arc Washer (M8)
Lock Washer (M10)
Lock Washer (M8)
Washer (M8)
Washer (M4)
Nylock Nut (M10 x 1.5)
Nylock Nut (M8 x 1.25)
6
1/2 5 1/2
length
length
Meijer.com
6
in.
mm.
Qty
2
18
2
2
1
2
4
1
2
2
2
12
2
11
11
1
2
3