Avari Fitness AVARI 2000R Recumbent Bike Owner's Manual page 11

ASSEMBLY INSTRUCTIONS
STEP 10:
Slide the UPRIGHT SLEEVE(71) over the UPRIGHT(11). Insert the TENSION CABLE(32)
through the UPRIGHT(11) until the TENSION CABLE(32) is through and extends out of the square opening
in the side of the UPRIGHT(11). Connect the CONNECTION WIRE(33) to the SENSOR WIRE(31). Slide the
UPRIGHT(11) onto the MAIN FRAME(1) and secure with BUTTON HEAD BOLTS(M8x1.25x20mm)(49),
LOCK WASHERS(M8)(65), WASHERS(M8)(61), and ARC WASHERS(M8)(58). Slide down the UPRIGHT
SLEEVE(71) to cover the bolt heads.
STEP 11:
Attach the TRAY(72) to the UPRIGHT(11) with ROUND HEAD SCREWS(M4x30mm)(55).
STEP 12:
Refer to the inset drawing and the illustration below. To connect the TENSION KNOB(26) to
the TENSION CABLE(32):
1. Set the TENSION KNOB(26) at position "8", so the CABLE END extends out of the METAL FITTING
as far as possible. Connect the CABLE END of the TENSION KNOB(26) to the HOOK on the end of the
TENSION CABLE(32).
2. Pull on the Cable of the TENSION KNOB(26) firmly so that enough cable is available to allow the METAL
FITTING go through the slot in the top of the BRACKET.
3. Insert the METAL FITTING into the hole at the end of the slot in the BRACKET.
4. Adjust the TENSION KNOB(26) and verify that the HOOK moves when the TENSION KNOB(26) is
adjusted.
5. Attach the TENSION KNOB(26) to the UPRIGHT(11) with ROUND HEAD SCREW(M4x0.7x25mm)(54)
and WASHER(M4)(63).
11
Meijer.com
Metal Fitting
Cable End
1
Hook
Bracket
2
3