Table of Contents
Advertisement
Completing the parts replacement
After replacing a failed part, you need to install any other removed parts, install
the computer cover, and reconnect any cables, including telephone lines and power
cords. Also, depending on the part that was replaced, you might need to confirm
the updated information in the Setup Utility program. See "Starting the Setup
Utility" in your Quick Reference.
To complete the installation:
1. Ensure that all components have been reassembled correctly and that no tools
2. Clear any cables that might impede the replacement of the computer cover.
3. Position the computer cover on the chassis so that the rail guides on the bottom
or loose screws are left inside your computer. See "Locating components" on
page 1 for the location of the various components.
of the computer cover engage the rails. Then, push the computer cover closed
until it latches.
Chapter 2. Replacing hardware
31
Advertisement
Table of Contents
