Replacing the mouse
1. Remove any media (diskettes, CDs, or tapes) from the drives, shut down the
2. Unplug all power cords from electrical outlets.
3. Locate the mouse connector. See "Locating connectors on the rear of the
4. Disconnect the failing mouse cable from the computer and connect the new
5. Go to "Completing the parts replacement" on page 31.
Attention:
Do not open your computer or attempt any repair before reading the "Important safety
information" in the Quick Reference that was included with your computer or in the
Hardware Maintenance Manual (HMM) for the computer. To obtain copies of the Quick
Reference or HMM, go to http://www.ibm.com/pc/support/.
computer, and turn off all attached devices.
computer" on page 3 and "Locating connectors on the front of the computer"
on page 2.
Your mouse might be connected to the standard mouse connector 1 at the
rear of the computer or to a USB connector 2 at either the front or rear of the
computer. Locate the connector for the mouse.
mouse cable to the same connector.
Chapter 2. Replacing hardware
29