Module Test Menu And Hardware Configuration Report - IBM 2179 Hardware Maintenance Manual

If NO, continue to 002 .
If YES, proceed to 003 .
If the Power Management feature is enabled, do the following:
1. Start the Configuration/Setup Utility program (see "Setup Utility program" on
2. Select Power Management from the Configuration/Setup Utility program
3. Select APM.
4. Be sure APM BIOS Mode is set to Disabled. If it is not, press Left Arrow (}) or
5. Select Automatic Hardware Power Management.
6. Set Automatic Hardware Power Management to Disabled.
7. Go to "IBM PC Enhanced Diagnostics" on page 6.
Run the IBM PC Enhanced Diagnostics test. If necessary, refer to "Diagnostics and
test information" on page 5.
v If you receive an error, replace the part that the diagnostic program calls out or
v If the test stops and you cannot continue, replace the last device tested.
v If the LCD display has problems such as black screen, blinking on-off, or the

Module test menu and hardware configuration report

Depending on the diagnostics version level you are using, the installed devices in
the computer are verified in one of two ways:
1. At the start of the diagnostic tests, the Module Test Menu is displayed.
2. At the start of the diagnostic tests, the main menu appears. From this menu,
If an installed device is not recognized by the diagnostics program:
v The diagnostic code for the device is not on the diagnostics provided with that
v The missing device is defective or it requires an additional diskette or service
v An unrecognizable device is installed.
v A defective device is causing another device not to be recognized.
v The SCSI controller failed (on the system board or SCSI adapter).
v Use the procedure in "Undetermined problems" on page 56 to find the problem.
If a device is missing from the list, replace it. If this does not correct the problem,
use the procedure in "Undetermined problems" on page 56.
2
Hardware Maintenance Manual
002
page 5.)
menu.
Right Arrow (Æ) to change the setting.
OR
003
go to "IBM PC Enhanced Diagnostics" on page 6.
screen pallet color is wrong, go to "Display" on page 17.
Normally, all installed devices in the computer are highlighted on the menu.
select System Info then select Hardware Configuration from the next menu.
Normally, all installed devices in the computer are highlighted on this report.
device
manual.