Assembly - NordicTrack COMMERCIAL 1300 User Manual

ASSEMBLY

Assembly requires two persons. Place all parts of the elliptical exerciser in a cleared area and remove the
packing materials. Do not dispose of the packing materials until assembly is completed.
Assembly requires the included tool(s) and your own Phillips screwdriver
wrench , and rubber mallet
As you assemble the elliptical exerciser, use the drawings below to identify small parts. The number in parenthe-
ses below each drawing is the key number of the part, from the PART LIST near the end of this manual. The
number following the parentheses is the quantity needed for assembly. Note: If a part is not in the hardware
kit, check to see if it has been preassembled.
5/16" Locknut
(106)–4
5/8" Wave
Washer (102)–6
5/16" x 1" Patch
Screw (81)–11
M6 Split
Washer
5/16" Split
(111)–10
Washer (105)–5
#8 x 3/4"
Pivot Spacer
Screw (78)–4
(71)–4
5/16" x 2 1/2" Button
Screw (88)–8
.
M10 Split
Washer (80)–10
Washer (110)–6
#10 x 1/2"
Screw (79)–10
5
, adjustable
#10 Fender 5/16" Washer
(104)–6
5/16" x 1.5" Button
Bolt (73)–4
M10 x 20mm Patch
Screw (108)–6