Replacing Or Adding A Memory Module - Dell Vostro 420 Service Manual

Replacing or Adding a Memory Module

NOTICE:
NOTICE:
memory upgrade, keep them separate from any new modules, even if you
purchased the new modules from Dell. If possible, do not pair an original memory
module with a new memory module. Otherwise, your computer may not start
properly. The recommended memory configurations for Vostro 420 are:
1) A pair of matched memory modules installed in DIMM connectors 1 and 2, or
2) A pair of matched memory modules installed in DIMM connectors 1 and 2 and
another matched pair installed in DIMM connectors 3 and 4.
NOTE:
800-MHz) memory modules, the modules function at the speed of the slowest
module installed.
NOTE:
connector closest to the processor, before you install modules in any other
connector.
NOTE:
accommodate two DIMMs.
2
1 Pair A: matched pair of memory
modules in connectors DIMM_1 and
DIMM_2
104
Memory Module(s)
Do not install ECC memory modules.
If you remove your original memory modules from the computer during a
If you install mixed pairs of PC2-5300 (DDR2 667-MHz) and PC2-6400 (DDR2
Ensure that you install a single memory module in DIMM connector 1, the
Vostro 420 can accommodate four DIMMs; Vostro 220 and Vostro 220s can
1
2 Pair B: matched pair of memory
modules in connectors DIMM_3 and
DIMM_4