IBM THINKCENTRE 8086 User Manual page 33

Note: A serial ATA hard disk drive does not have a master/slave jumper.
10. Depending on the type of drive you are installing, go to "Connecting a
parallel ATA hard disk drive" or "Connecting a serial ATA hard disk drive."
Connecting a parallel ATA hard disk drive
1. Locate the two-connector signal cable that comes with your computer or with
the new drive.
2. Locate the hard drive cable connector on the system board. See "Identifying
parts on the system board" on page 11.
3. Connect one end of the signal cable to the drive and the other to the hard drive
cable connector on the system board.
4. Locate the extra four-wire power connector and connect it to the drive.
What to do next:
v To work with another option, go to the appropriate section.
v To complete the installation, go to "Closing the cover and connecting the
cables" on page 23.
Connecting a serial ATA hard disk drive
1. Locate the signal cable that comes with the new drive.
2. Locate the SATA connector on the system board. See "Identifying parts on the
system board" on page 11.
3. Connect one end of the signal cable to the drive and the other to the SATA
connector on the system board.
4. Locate the extra five-wire power connector and connect it to the drive.
What to do next:
v To work with another option, go to the appropriate section.
v To complete the installation, go to "Closing the cover and connecting the
cables" on page 23.
Chapter 1. Installing options
19