Display Subcomponents (Bezel, Webcam, Panel) - HP Compaq 15 Maintenance And Service Manual

Display subcomponents (bezel, webcam, panel)

This section describes removing display subcomponents that do not require that you remove the entire
display assembly from the computer. You can remove the display bezel, webcam/microphone module, and
display panel while the display assembly is still attached to the computer.
To remove the remaining display subcomponents, you must remove the entire display assembly from the
computer. See
its entirety.
Description
Raw display panel
Display bezel for use with HP models
Display bezel for use with Compaq models
Webcam/microphone module
Before removing display subcomponents while the display assembly is still attached to the computer, follow
these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet and
then unplugging the AC adapter from the computer.
4. Remove the battery (see
To remove the display bezel, webcam/microphone module, and raw display panel:
1. Position the computer upright with the front toward you, and then open it.
2. Flex the inside of the top edge (1), the left and right sides (2), and the bottom edge (3) of the display
bezel until the bezel disengages from the display enclosure.
34 Chapter 4 Removal and replacement procedures
Display assembly on page 66
Battery on page
for more information about removing the display assembly in
33).
Spare part number
750635-001
749644-001
749645-001
749654-001