Bissell 1660 User Manual page 9

Getting ready
1. Attach bare floor attachment to bottom of floor nozzle with
rubber and brush strips facing out. Align front edges and
snap together.
2. Fill measuring lid twice with BISSELL Floor Care and empty
into filling cavity.
3. Pour two gallons of hot tap water into filling cavity.
Water level should reach the bottom of three vertical lines
in tank unit.
Cleaning
1. Turn vacuum/suction and pump/spray switches on.
2. Depress trigger and pull floor nozzle toward you.
3. Release trigger and repeat action to extract excess moisture.
4. Disconnect bare floor attachment. Turn off machine,
hold floor nozzle away from you, push bare floor tool off
with thumbs.
5. See WHEN YOU'RE DONE, page 7 and PUTTING IT AWAY,
page 11.
How to dry vacuum
How to clean bare floors
Vacuum/suction switch
Pump/spray switch
1. Make sure tank unit is dry before proceeding.
2. Check motor filter. Clean if necessary.
3. Pull dry filter bag over ball cage, catching edge of bag
over lip at bottom of cage.
4. Place ball on raised area at bottom of tank unit.
5. Position ball cage over ball and press firmly onto
raised area.
Tip:
6. Remove two small aluminum wand clips and floor nozzle
from wand.
Always check
7. Attach one of four dry vacuuming tools.
motor filter
8. Insert tank siphon tube in tank unit.
before dry
vacuuming.
9. Turn on vacuum/suction switch. Vacuum as usual.
Clean if
10. Empty collection tank when it is half full.
necessary.
11. See PUTTING IT AWAY, page 11.
Vacuum/suction switch
Pump/spray switch
Floor Nozzle
Bare Floor
Attachment
To clean bare floors, attach
Bare Floor Attachment to
bottom of Floor Nozzle with
the rubber and brush strips
facing out. Align front edges
and snap together.
9