Replacement; Wiper Blade Replacement - Chevrolet 2013 Equinox Owner's Manual

Hide thumbs Also See for 2013 Equinox:
Table of Contents

Advertisement

Park on a fairly steep hill, with the
vehicle facing downhill. Keeping
your foot on the regular brake, set
the parking brake.
To check the parking brake's
holding ability: With the engine
running and the transmission in
N (Neutral), slowly remove foot
pressure from the regular brake
pedal. Do this until the vehicle is
held by the parking brake only.
To check the P (Park)
mechanism's holding ability:
With the engine running, shift to
P (Park). Then release the
parking brake followed by the
regular brake.
Contact your dealer if service is
required.

Wiper Blade Replacement

Windshield wiper blades should be
inspected for wear and cracking.
See Maintenance Schedule on
page 11 3.
Replacement blades come in
different types and are removed in
different ways. For proper type and
length, see Maintenance
Replacement Parts on page 11 13.
Notice: Allowing the wiper arm to
touch the windshield when no
wiper blade is installed could
damage the windshield. Any
damage that occurs would not be
covered by your warranty. Do not
allow the wiper arm to touch the
windshield.
Front Wiper Blade

Replacement

To replace the front wiper blades:
1. Lift the wiper arm from the
windshield until no further
movement is possible.
I n f o r ma t i o n P r o v i d e d b y :
Vehicle Care
2. Press the square button on the
top side, at the end of the wiper
arm, and pull the wiper blade out
of the end of the wiper arm.
3. Install the wiper blade connector
by sliding into the end of the
wiper arm until the square button
on the wiper blade clicks into
place with the wiper arm.
4. Place the wiper arm with the
wiper blade in place back on the
windshield.
Rear Wiper Blade Replacement
The rear wiper blade and wiper arm
have a cover for protection. The
cover must be removed before the
wiper blade can be replaced.
10-25

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents