Edimax Wireless Multi-Homing Broadband Router User Manual page 69

Protocol
WAN Port
Add a Rule
Remove a Rule
Click <Apply> at the bottom of the screen to save the above configurations. You can now
configure other advance sections or start using the router (with the advance settings in place)
Only packets with this assigned protocol will statically bind to the
assigned WAN port.
The WAN port that the packets matching this rule are statically
bound to.
Fill in the "Source IP Range", "Destination IP Range",
"Source Port Range", "Destination Port Range", "Protocol"
or "WAN Port" of the setting to be added and then click
"Add". Then this rule of Protocol and Port Binding will be
added into the "Protocol and Port Binding Table" below. If
you find any typo before adding it and want to retype again,
just click "Clear" and the fields will be cleared.
If you want to remove some rule of Protocol and Port
Binding from the "Protocol and Port Binding Table", select
the rules you want to remove in the table and then click
"Delete Selected". If you want remove all rules from the
table, just click "Delete All" button. Click "Reset" will
clear your current selections.
69