Daikin FTXS20J2V1B Operation Manual page 36

3-2 Titanium apatite photocatalytic air-purifying filter
The titanium apatite photocatalytic air-purifying filter can be renewed by washing it with
water once every 6 months. We recommend replacing it once every 3 years.
[Maintenance]
3-2-1 Vacuum dusts, and soak in warm water
or water for about 10 to 15 minutes if dirt
is heavy.
• Do not remove the filter from frame when
washing with water.
3-2-2 After washing, shake off remaining
water and dry in the shade.
• Since the material is made out of
polyester, do not wring out the filter when
removing water from it.
[Replacement]
3-2-3 Remove the tabs on the filter frame and
replace with a new filter.
• Do not throw away the filter frame. Reuse
the filter frame when replacing the
titanium apatite photocatalytic air-
purifying filter.
• Dispose of the old filter as non-flammable
waste.
4. Set the air filter and titanium apatite
photocatalytic air-purifying filter as they
were and close the front panel.
• Insert claws of the filters into slots of the front panel.
Close the front panel slowly and push the panel at
the 3 points. (One on each side and one in the
middle.)
NOTE
• Operation with dirty filters:
(1) cannot deodorize the air.
(3) results in poor heating or cooling.
• To order titanium apatite photocatalytic air-purifying filter contact to the service shop there
you bought the air conditioner.
• Dispose of the old filter as non-flammable waste.
Titanium apatite photocatalytic air-purifying filter
(without frame) 1 set
(2) cannot clean the air.
(4) may cause odour.
Item
Push
Part No.
KAF970A46
35