Honeywell ADEMCO VISTA-12A Installation And Setup Manual page 46

Installation and Setup Guide
FIELD TITLE and DATA ENTRIES
Auto-Stay Arm
*84
0 = no
1 = partition 1 only
2 = partition 2 only
4 = partition 3 only
Add values for multiple partitions (e.g., for
partitions 1 and 2, enter 3).
Linked Zone Verification Timer \Up and
*85
About
Linked Zone Timer Entry:
0 = 15 secs
1 = 30 secs
2 = 45 secs
3 = 60 secs
4 = 90 secs
5 = 2 min
Up and About Timer Entry:
1 through 15 for number of hours
Cancel Verify Keypad Display
*86
0 = no "Alarm Canceled" display
1 = yes, display "Alarm Canceled"
4-10
6 = 2-1/2 min #+12 = 8 min
7 = 3 min #+13 = 10 min
8 = 4 min #+14 = 12 min
9 = 5 min #+15 = 15 min
#+10 = 6 min
#+11 = 7 min
EXPLANATION
If enabled, the system will automatically change
AWAY or MAXIMUM modes to STAY and
INSTANT modes respectively if the entry/exit door
is not opened and closed within the exit delay time
after a user arms in AWAY mode from a wired
keypad (non-RF device). An Opening report
followed by an Armed Stay report is sent to the
Central Station.
If the door is opened and closed within the exit
delay period, the system remains in AWAY or
MAXIMUM mode.
Any RF device that arms the system AWAY
overrides this feature and the system remains
armed in the AWAY mode.
NOTE: Must not be used if TeleCommand is used.
Does not apply if:
• Final Contact Set exit option (field *88,
option 3) is enabled.
• Blockschloss is being used.
Linked Zone Timer: Sets the maximum amount of
time in which two linked zones must be tripped in
an armed system to send an alarm message to the
Central Station. If only one linked zone is tripped
during this time, a trouble message (CID code 380)
for that zone is sent to the Central Station.
Assign linked zone pairs in zone list 4.
Up and About Timer: 1-15 hours. This option is
part of an Up and About schedule (event 12) that
must be programmed. The value in this field is the
time within which activity must occur within the
overall scheduled up and about time window. If no
zones are faulted or no key is pressed within the
selected time period during the scheduled Up and
About time window, a report is sent to the central
station. This can serve as a safety feature for
elderly, infirm, or disabled persons. See
Programming Installer and User Schedules
section for programming schedules.
When enabled (1 = yes), this feature causes an
"ALARM CANCELED" display at the keypad
whenever the system is disarmed after an alarm
has occurred.
NOTE: To clear the "ALARM CANCELED"
display, the user must enter the security code +
OFF.