Using The Hd-15 High-Density Connector; Installing The Nxa-Avb/Rgb - AMX Modero NXD/NXT-1200VG Operation/Reference Manual

Touch Panel Accessories

Using the HD-15 high-density connector

Connect the RGB/Comp source equipment HD-15 (male) connector to the RGB/COMPONENT HD-15 high-
density connector (female) on the rear of the NXA-AVB/RGB Breakout Box. The following table below lists
the HD-15 connector pinouts.
HD-15 Connector Pinouts
Pin Signal
1 Red
2 Green
3 Blue
4 N/A
5 GND
6 RAGND Red analog ground
7 GAGND Green analog ground
8 BAGND Blue analog ground
9 N/A
10 SAGND Synchronization analog ground
11 N/A
12 N/A
13 HSYNC
14 VSYNC
15 N/A

Installing the NXA-AVB/RGB

A 12 VDC-compliant power supply can indirectly provide power to a Modero panel by routing power through
the NXA-AVB/RGB Breakout Box. FIG. 3 shows a sample wiring configuration using both an indirect or
direct power connection for a VG-Series Modero panel.
12 VDC power
supply
Indirect
Connect
supplied via
Breakout Box
12 VDC power
supply
Direct
Connect
FIG. 3 Sample Wiring configuration using the NXA-AVB/RGB Breakout Box
16
Function
Red signals/Cr
Green signals/Y
Blue signals/Cb
Not used
Signal Ground
Not used
Not used
Not used
Horizontal synchronization signal
Vertical synchronization signal
Not used
Ethernet
(RJ-45)
Video In
(BNC)
NXA-AVB/RGB
Breakout Box
Power
Ethernet
(CAT5)
or
VG-Series and Video-capable
Touch Panels
10
5
1
6
HD-15 (male)
connector
Mic Out
Audio In Line Level out
(4-pin)
(6-pin)
(to amplifier
or VOL card)
USB
(pass-thru)
RGB In (HD-15)
Audio/Video RGB (RGB and touch
(CAT5) control) (CAT5)
15
11
(rear)
(front)
VG-Series Modero Touch Panels