Table of Contents
Advertisement
3.
Connect the HDD into the Cartridge Casing
Take the Hard Disk Drive and connect the two cables from the back of the Cartridge Casing to the HDD.
The cables should be pushed in firmly, but not forcibly.
NOTE:
Ensure that the jumper on the back of the HDD is set to 'Master' or 'CS (Cable
Select)'. Please refer to the label on the HDD for the correct settings, as these will
vary dependant upon model and manufacturer.
4.
Secure the HDD in the Casing (optional)
Insert the six supplied screws (found in empty cartridge) and tighten them, positioning the HDD into
place. This step is optional, but it is recommended.
5.
Slide the top Cover over the Cartridge Casing
Slide the Cover forward over the Cartridge Case. Ensure it is secured in place over the release latch.
21
Advertisement
Table of Contents
