Advertisement
Troubleshooting Guide
What might appear to be a malfunction in your unit may just be the result ofslight misoperation or miswiring. Before calling service, first check the following
table for possible problems.
PROBLEM
"/'
POSSIBLE CAUSE
SOLUTION
No sound.
• Input (or output) cables are disconnected.
• Connect the input (or output) cables.
• Protection circuit may be activated.
• Check connections by referring to <Protection function>.
(Blown fuse.)
• Volume is too high.
• Replace the fuse and use lower volume.
• The speaker cord is shorted.
• After check the speaker cord and fixing the cause of the short,
reolace the fuse.
The output level is too small
• The input sensitivity adjusting control is not set to the correct
• Adjust the control correctly referring to <Controls>.
(or too larqe).
position.
The sound quality is bad.
• The speakers wire are connected with wrong
EEl /8
polarity.
• Connect them properly checking the
EEl / 8
of the terminals
(The sound is distorted.)
and wires well.
• A speaker wire is pinched by a screw in the car body.
• Connect the speaker wire again so that it is not pinched by
anything.
· The switches mav be set improperlv.
• Set switches properlv bv referrina to <Controls>.
The Remote Controller does
• The Remote Cable is disconnected.
• Connect the Remote Cable securely and correctly.
not function.
.lPecifications
Specifications subject
to
change without notice.
CEA-2006
RMS Watts per channel
@
4 ohms, 1 % THO+N ..
Signal to Noise Ratio (Reference: 1Watt into 4 ohms) ..
.........
.
800 W xl
....................................................................... 7S dBA
~,
.....
, .~
c• . :
,.
,,'
"'A·2~
.
2400W
Audio Section
Max Power Output ...
Rated Power Output (+B
=
14.4 V)
(40) (20 Hz - 200
1.0 % T H O ) . . .
800 W x 1
(20)(100Hz,1.00/0
nul
1200Wx1
Frequency Response (+0,
-3
dB)
20 Hz - 200 Hz
Sensitivity (rated output) (MAX.) .
.
..0.2 V
(MIN).
.
50V
Input Impedance
10 kO
5ignal to Noise Ratio...
.
105 dB
Low Pass Filter Frequency (-24
- 200 Hz (variable)
Infrasonic Filter Frequency (-24
15 - 40 Hz (variable)
Bass Boost Level (Optional accessory)...
.
0 - 18 dB (variable)
Bass Boost Frequency (Optional accessory)..
.
..40 - 100 Hz (variable)
General
Operating Voltage
14.4 V (11 - 16 V allowable)
Current Consumption..
.
90 A
Installation Size (W x H x 0)
380 x 66 x 286 mm
................................................................................................................................................................................14-15/16 x 2-5/8 x 11-1/4 inch
Weight..
.
.5.0 kg (11.0 Ibs)
English
7
Advertisement
