Grease Filters; Vent Controls; Using The Hood Controls; Care And Cleaning Of The Vent Hood - GE JV535 Owner's Manual And Installation Instructions

Using the hood controls.

Throughout this manual, features and appearance may vary from your model.
Control Knobs
(on some models)
OFF
LO
MED
HI
FAN
MAX
FAN Control
Turn to LO, MED, HI or MAX as needed.
Continuous use of the fan system while cooking
helps keep the kitchen comfortable and less humid.
It also reduces cooking odors and soiling moisture
that create a frequent need for cleaning.
LIGHT Control
Turn to HI while cooking or to NITE for use as
a night light.

Care and cleaning of the vent hood.

Be sure electrical power is off and all surfaces are cool before cleaning or servicing any part of the vent hood.
Filter locks
If it ever becomes necessary to replace
the metal grease filters, they may be
ordered from your GE supplier.
OFF
HI
NITE
LIGHT
Reusable Metal Grease Filters
The hood has 2 metal reusable

grease filters.

The metal filters trap grease released
by foods on the cooktop. They also
help prevent flaming foods on the
cooktop from damaging the inside
of the hood.
For this reason, the filters must
ALWAYS be in place when the hood
is used. The grease filters should
be cleaned once a month, or
as needed.
To remove, press the filter locks
back and pull the filters down
and out.
To replace, insert the rear filter tabs
in the frame slots at the back of the
opening. Push the filters up and lock
them into place.
Rocker Switch Controls
HI
OFF
LOW
FAN
FAN Control
Press the rocker switch at the top to turn the fan on
HI and at the bottom to turn it on LOW . The center
position is OFF .
Continuous use of the fan system while cooking
helps keep the kitchen comfortable and less humid.
It also reduces cooking odors and soiling moisture
that create a frequent need for cleaning.
LIGHT Control
Press the rocker switch at the top to turn the light ON
while cooking. Press the rocker switch at the bottom
for use as a night light. The center position is OFF .
To clean the grease filters, soak
them and then swish them around
in hot water and detergent.
Don't use ammonia or ammonia
products because they will darken
the metal. Do not use abrasives or
oven cleaners. Light brushing can
be used to remove embedded dirt.
Rinse, shake and let them dry before
replacing. They may also be cleaned
in an automatic dishwasher.
NOTE: Before cleaning, make sure the
charcoal filters, if present, are unclipped and
removed. See the Charcoal Filters section.
(on some models)
HI
OFF
NITE
LIGHT
3