Table of Contents
Advertisement
About Advanced Features & Operation
The most common way to program the EasyStat thermostat
is to program it just as you would an alarm clock. You program
the stat in the HEATING MODE, normal winter operation, and
you can also program it in the COOLING MODE, normal
summer operation. It will keep these set points stored and use
them any time that the program is on, (WAKE/SLEEP -shown on
display). It will only use the COOLING set points when the mode
is in cooling and only use the HEATING set points when the
mode is heating.
To program the thermostat, just put it in the HEATING or
COOLING MODE, press the SET PROGRAM button, and then
the WAKE TIME will flash. Use the UP and DOWN keys to
select the time that you wish to have the temperature turned up
in the morning. You should probably set the time for about 15
minutes before you awake for air conditioning or gas heat, and
about 30 minutes ahead of when you wake for heat pump
operation. Press the MODE/NEXT button again and simply use
the UP and DOWN keys to select the temperature you wish the
next morning.
Press the MODE/NEXT key again and do the same adjustments
as above for the SLEEP period. This will be for the normal
operation where you wish to have the temperature set back
when you go to bed at night and then set up to a comfortable
temperature when you get up in the mornings.
Another way to program this thermostat is for those who wish to
set the temperature back manually before they go to bed at
night, but wish to wake to a comfortable room and also wish to
set the temperature back when they leave for work, but wish to
return to a comfortable house. Simply think of the SLEEP
period as a RETURN period. Set the WAKE period for a
comfortable temperature when you wake in the mornings and
the SLEEP period for a comfortable temperature for when you
return from work.
Page 14
Page 14
Advertisement
Table of Contents
