Av In Jack; Display; Subwoofer; Radio Operations - Hyundai H-CMD7080 Instruction Manual

are used only for rear zone operation).
Please note that for DUAL ZONE mode
an additional display and an amplifier with
acoustics should be connected to this unit. Or
you can use a car TV set with built-in speakers.

AV in jack

AV jack is intended to receive audio and video
signals by connecting to external device.

Display

Press DUAL/DISP button on the RC to
display current tuning information and time.
In Radio mode, display menu: Clock/Time
=> PTY => Radio Frequency => PS (Program
Service, if available) => Exit Display.
In Disc/USB/SD mode, except the above
menu, it will also show ID3 information if the file
with ID3 tags.

Subwoofer

Press and hold MODE button to enable or
disable subwoofer. For subwoofer operation an
external amplifier is required.

Radio operations

Band selection

Press repeatedly BAND button on the panel
or RDM/BAND button on the RC to select your
desired radio band in RADIO mode: FM1, FM2,
FM3, AM1 (MW1), AM2 (MW2). In each set of
the bands you can store up to 6 preset stations,
making total 30 preset memory stations.
Manual/automatic tuning
Manual tuning: To find a station, select a
band first, then press and hold
on the RC until MANUAL appears on the
display, then press these buttons repeatedly
to search for the needed frequency upward or
downward.
Automatic tuning: To find a station, select a
band first, then press and hold
on the panel or press
/ buttons
/ buttons
/ buttons on the
RC, the automatic downward/upward search
will start. It will play when a station is found.

Programming preset stations

• To store a station: Select a band (if
needed); find a station by manual/automatic
tuning. Then press MEM button and rotate
VOLUME knob to choose a memory position
(1-6), and finally press OK button to confirm.
Or, after finding a station, press and hold a
number button (1-6) on the RC to save the
station in the corresponding memory position.
• To recall a station: Select a band (if
needed); press MEM button on panel, then rotate
VOL knob to choose (1-6), and finally press OK
button to confirm the needed station. Or press a
number button (1-6) on the RC to call the station
saved in the corresponding position.

Auto memory store

Select a band, press and hold RPT/P.SCAN
button on the RC to enter auto store mode.
The radio will automatically store 6 stations to
the 6 preset memories of the current band. To
stop auto store, press this button again.
During auto station preset, the unit will
search and store stations with the strong signal
first, and then weaker signal stations until the
memories are full.

Preset scan

Select a band, press RPT/P.SCAN button
on the RC to scan all preset stations in the
memories of the current band, each preset
scan for 5 seconds. To stop preset scan, press
the button again.

RDS function

RDS (Radio Data System) service availability
varies with areas. Please understand if RDS
service is not available in you area, the
following service is not available, either.

AF (Alternative Frequencies)

function

Press and hold MEM button on the front
Operation
13