Dear customer! Thank you for purchasing our product. For safety, it is strongly recommended to read this manual carefully before connecting, operating and/or adjusting the product and keep the manual for reference in the future. Table of contents Table of contents ...2 Important safeguards ...3 Accessories...4 Installation/connection...5...
Important safeguards Using the device at temperature below -10º may cause the breakage of the device. Before using please heat up the passenger compartment to the recommended temperature! Disconnect the vehicle's negative battery terminal while mounting and connecting the unit. When replacing the fuse, be sure to use one with an identical amperage rating.
Accessories Receiver Remote controller Panel protective case AV cable USB cable Mounting parts: set ISO cable Release keys Screw Bolt Washer Mounting strap Rubber Customer information Warranty card Instruction manual 1 pc 1 pc 1 pc 1 pc 1 pc 1 pc 2 pc 1 pc...
Installation/connection Attention: Remove the transport CD stopper (2 screws) before use. Din front-mount (method 1) After inserting the holder into the dashboard, select the appropriate tab and bend them inwards to secure the holder in place. 1. Dashboard 2. Nut (5mm) 3.
Page 6
Din rear-mount (method 2) Installation using the screw holes at both sides of the unit. 1. Select a position where the screw holes of the main unit are fitted for aligned, and tighten the screws at 2 positions at each sides. Use either truss screws (5 x 8mm) or flush surface screws (4 x 8mm), depending on the shape of the screw holes in the bracket.
Page 7
Attaching the control panel 1. Insert the right side of the control panel into the main unit (pic. 3). 2. Press the control panel on to the left side of middle of it until a “click” sound is heard (pic. 4). Caution: Do not insert the control panel from the left side.
Page 8
Electrical connection Caution: Do not interchange the connection of the wiring! For some car models you may need to modify wiring of the supplied power cord. Contact your authorized car dealer before installing this unit. Note: 2 cable is connected to a Hands-Free device (not included).
Page 9
Parking wire NThe parking wire is connected with brake signal; for safety, the programs can be seen on the monitor after braking the car.
Page 13
Changing the battery 1. Press the catch and at the same time pull out the battery tray. 2. Insert the 1 x lithium battery, type CR 2025 3V battery with the stamped (+) mark facing upward. Insert the battery tray into the remote control. Warning: Store the battery where children cannot reach.
General operations Reset the unit Operating the unit for the first time or after replacing the car battery, you must reset the unit. Press OPEN button on the panel to open the panel and press RESET button to restore the unit to the original factory settings.
Page 15
Setting other characteristics During TUNER mode press SEL button and hold for 2 seconds, shortly and repeatedly press SEL button to select the setting: TA SEEK => PI MUTE => RETUNE L => MASK DPI =>TA VOL => EON TA =>BEEP=>...
Page 16
BEEP Turn BEEP on if you want the pressing of buttons to be sounded. Press SEL button until the display shows BEEP, then press VOL +/- buttons to turn BEEP sound ALL or OFF or 2 (you hear BEEP sound when you press the button over 1.5 seconds).
Digital tuner operations Note: RDS (Radio Data System) service availability varies with areas. Please understand if RDS service is not available in you area, the following service is not available, either. RDS overview PI: Program Identification Code – for identifying code. PS: Program Service Name Broadcast –...
Page 18
Select a band (if needed) Select a station by pressing T-DN/T-UP buttons on the panel or PREVIOUS/NEXT buttons on the RC. Hold a Preset button (1-6), which you want store the station for at least 2 seconds. To recall a station: Select a band (if needed) Press a Preset button (1-6) briefly to recall the stored station.
Page 19
AF (Alternative Frequencies) function Press AF/MONO button on the panel shortly to turn on or turn off the AF function. If the AF function is on the display will show “AF”. When AF switching mode is selected, but RDS information is not received yet the “AF”...
Disc glossary PBC (PlayBack Control) PBC is a menu recorded on the disc with SVCD or VCD2.0 format. For the discs contained PBC, it can playback interactive software with the menu displayed on TV. And if the disc contains still images, it can playback high definition of still image.
DVD/SD/MMC/USB operations Discs for playback This unit can play disc types: DVD/DVD±R/±RW/CD/CD-R/CD-RW. Compatible with formats: DVD/SVCD/VCD/DVD Audio/CDDA/MP3/CD/WMA/ HDCD/Picture-CD/ Photo-CD/JPEG. The following file types are supported: Audio files: MP3 (*.mp3) WMA (*.wma) Video files: MP4 (*.avi, DIVX3.11/4.0/5.0/6.0 and XVID) MPEG 2(*.vob) MPEG 1(*.dat) Picture file: JPEG (*.jpg) ISO 9660 or ISO 9660 +Joliet format - Max.
Page 23
Loading/Ejecting a disc Turn the power on. Press OPEN button on the panel. Insert the disc with the printed side facing upward into the slot. Press EJECT button on the inner side to eject the disc. Inserting the SD/MMC card/USB device Insert the MMC/SD card or USB device into MMC/SD compartment or USB socket.
Page 24
Loudness Press and hold #/BAND/LOUD button to turn loud on or off. Repeat playback Press RPT button to start repeat playing. Press one more time to cancel. The repeating sequence: In MP3 mode: FILE => FOLDER => ALL. In DVD mode: Repeat OFF => Repeat TITLE => Repeat Chapter. In CD mode: Disc =>...
Page 25
Changing size (for DVD/VCD) During playback press and hold A-B/ZOOM button on the RC. The picture will be enlarged accordingly: X2=> X3=> X4=> X1/2=> X1/3=> X1/4=>Normal. A-B segment repeating Press A-B/ZOOM button to set A position, press one more time to set B position and start A-B repeating. Press this button one more time to cancel the repeating function.
Page 26
4. Press STOP/PBC button to “STOP”, and press PLAY/ PAUSE button to continue playing. 5. Press STOP/PBC button to “STOP”, press again to “R.STOP”, and press PLAY/ PAUSE button to playback. Program playing During playback press PROG/PTY button on the RC to open the program menu. Press number buttons to select the track number and then press cursor buttons to move the cursor to PLAY.
MP3 overview Notes on MP3: MP3 is short for MPEG Audio Layer 3 and refers to an audio compression technology standard. This product allows playback of MP3 files on CD-ROM, CD-R or CD-RW discs. The unit can read MP3 files written in the format compliant with ISO 9660. However it does not support the MP3 data written by the method of packet write.
Page 28
Notes on creating your own CD-R or CD-RW containing MP3 files: To enjoy high quality sound, we recommend converting to MP3 files with a sampling frequency of 44.1 kHz and a fixed bit rate o f 128 kbps. DO NOT store more than 256 MP3 files per disc. For ISO 9660 - compliant format, the maximum allowable depth of nested folders is 8, including the root directory (folder).
DVD setup Press SETUP button to enter into the system settings main menu; press the left or right cursor buttons to move to the highlighted menu item and select one of the Setup Pages: Language, Display, Audio, Parental. Note: The OSD menu is only available on external monitor connected to the receiver. Language setup: Press SETUP and then ENTER to enter into LANGUAGE setup menu.
Page 30
Display setup: TV Display setup Set TFT screen mode to the correct ratio: Three screen ratio modes are available, Normal/PS (4:3 Pan Scan), Normal/LB (4:3 Letterbox) and Wide (16:9). Different disc formats will display different images depending this setting and the screen size used. TV Type setup Select this menu item to set up your preferred video output format.
Page 31
Stereo is normal Stereo, L-Mono is all sound on the Left Audio output, R-Mono is all sound on the Right channel. The “Mix-Mono” function only works when a DVD is being played in DTS 5.1 mode. Dynamic setup This function is to adjust the linear compression rate to obtain the different compression results of the signals. Standard set to “OFF”...
Bluetooth operation (option) Feature: 1. Bluetooth specification V2.0 EDR compliant 2. Support HFP, A2DP, AVRCP. 3. Excellent ECHO cancellation with noise elimination 4. Dial 5. Display incoming and outgoing number 6. Call list 7. Phone book A2DP (Advance Audio Distribution Profile) A2DP is a function which can receive the audio frequency signal from mobile phone, amplify by car audio and play out by speaker.
Page 33
Pairing Before operation it needs to pair the mobile phone and receiver. Prepare your mobile phone for bluetooth connection. According to mobile manual pairing device, when searching new device (KBT), select it, put in pass code "8888" and confirm ok, device paring finished. Operate mobile connect to Bluetooth, after connecting Bluetooth, Bluetooth indicating LED will be on.
Page 34
name with this first letter not existed, the LCD will display the next name according the order from A-Z), press Accept call button “ ” once again to display the number, and then press it again to dial the number. (Press Reject call button “...
Handling discs Dirty, scratched or warped discs may cause skip ping or noise. Handle the disc only by the edges. To keep clean do not touch its surface. Discs should be stored in their cases after use to avoid scratches. Do not expose discs to direct sunlight, high humidity, high temperature or dust.
Troubleshooting guide Symptom The car ignition is not on. No power The fuse is blown. Disc cannot be loaded. Presence of disc inside the player. Disc cannot be read. Inserting the disc in upside down. (LCD shows “ERROR2”) Compact disc is extremely dirty or defective.
Page 37
Sound skips. The installation angle is more than 30 degrees. The disc is extremely dirty or defective. The radio does not work, The antenna cable is not connected the radio station the signals are too weak. automatic selection does not work. Adjust the installation angle to less than 30 degrees.
Specification General Power supply: Storage support: Compatible with: Current consumption: Maximum power output: Dimensions (L x W x H): Working temperature range: FM Stereo Radio Frequency range: Usable sensitivity: Preset memory stations: MW (AM) section Frequency range: Preset memory stations: Frequency response: S/N ratio (A-vtd): DSP sound effect:...
Page 56
TA ( AF ( AF/MONO PTY ( PTY/SCN POP M, ROCK M EAST M, LIGHT M CLASSICS, OTHER M JAZZ M, COUNTRY M /DSP VOL +/-, (ON) «AF». (ON). => (ON) (OFF). TA SEEK TA ALARM. (OFF) PTY/PROG => (1-6), NEWS, AFFAIRS, INFO SPORT, EDUCATE, DRAMA CULTURE, SCIENCE, VARIED...
Page 57
NATION M, OLDIES M FOLK M PTY. PTY/SCN LOCAL/DX ( LOC, TRAVEL, LEISURE, DOCUMENT LOCAL DISTANT (DX) ( SOCIAL, RELIGION, PHONE IN PTY.