Ceramic Refractory Lining; Decorative Bay Window - Majestic DVR33 Installation Instructions & Homeowner's Manual

3 The second terminal of the speed control unit is attached
to either terminal of the thermal sensor.
4 The second terminal of the thermal sensor is connected to
either terminal of the fan motor.
5 The second fan motor terminal is connected to the white
wire of the supply line.
Method B
(Using the EB-1 Box.)
For instruction on wiring the EB-1 Electrical Junction Box see
the section 'EB-1 Electrical Box Connection'.
C R
ERAMIC EFRACTORY
Ceramic refractory panels are available in kit form to line the
rebox area.
Appliance Model
DVR33 ............................ DV33CR
Take care when handling the refractory panels
as they are fragile until held in place and sup-
ported.
Installation,
refer to Figs. 44.
1. Remove the front frame/glass assembly.
2. Remove the logs.
3. Place the lower supports for the side refractory panels on
the base of the rebox. Place each support so that the
slotted hole ts over the forward screw head along the
edge of the base.
4. Lay the angular base panels in place on the oor of the
rebox on either side of the burner housing
5. Loosely attach the top adjustable tabs to the studs located
in the top of the rebox toward the front corners.
6. Place the rear refractory panel in place. Locate the lower
edge of the panel into the top lip of the rear log support.
7. Slide the side refractory panels into place to hold the rear
panel secure. Adjust the top adjustable tabs to hold the
side panel against the rebox wall and secure the tab.
Repeat the procedure on the other side.
8. Replace the logs and frame/glass assembly.
For esthetic purposes we recommend lining up the horizontal
mortar lines.
10002823/0
Fig. 43
P
ANELS
Kit Model
DVR33
Vermont Castings, Majestic Products
D
ECORATIVE
A decorative Bay Window kit is available for the DVR33.
When tting the Bay Window Kit the original
front frame/glass assembly MUST remain in
place. The Bay Window kit is tted over the
existing front glass.
Installation
1. Remove the existing bottom louvre assembly complete
with the hinges.
2. Remove the top louvre assembly
3. Assemble the Bay Window Kit according to the instruc-
tions supplied with the kit.
4. Place the 2 pieces of ceramic refractory along the base of
the bay window, Fig. 45
5. Hang the Bay Window Assembly over the existing front
frame & glass assembly.
6. Re-install the upper louvre assembly.
Do not remove the existing front frame and
glass panel.
Fig. 44
B W
AY INDOWS
Fig. 45
31