Tach Learning - Directed Electronics 591XV Installation Manual

2-9 2 nd IGNITION/ACCESSORY OUTPUT: This will allow the PINK/WHITE to be used as a 2 nd ignition or an
accessory.
2-10 ACCESSORY STATE DURING WAIT-TO-START: This will allow the programming of the accessory wire during
the wait-to-start period of a diesel motor. When ON the accessory comes on when the wait-to-start output is
activated and stays on, dropping out during crank and returning once the car has started. When OFF the acces-
sory will activate as a normal accessory.
2-11 2 nd STATUS OUTPUT: This status will activate 10 seconds after the car has started. It is intended to operate
the defogger circuit. The output can be programmed to a latched or a pulsed output. When programmed to the
latched output the status will only stay active for 10 minutes.
2-12 ANTI-GRIND ON/OFF: With the anti-grind On (default) the ground-when-armed output will be active during
remote start operation. If accessories such as a voice module or window module are added to the unit, it may be
necessary to program this feature off.

tach learning

To learn the tach signal:
1.
DRW-96
2.
3.
4.
40
Start the vehicle with the key.
Within 5 seconds, press and HOLD the Valet/Program switch.
The LED will light constant when the tach signal is learned.
Release the Program switch.
© 2003 Directed Electronics, Inc. Vista, CA