Relay Key Switch Interface Wire Connection Guide - Directed Electronics 591XV Installation Manual

relay key switch interface wire
connection guide
All except the red heavy gauge wires leading from the relay satellite are used to energize high current circuits in
the vehicle. It is crucial that these connections are made correctly so that they are capable of handling the
current demands. For this reason, scotch locks, T-taps and other such connectors should not be used.
PURPLE (+) starter output
After cutting the starter wire connect the PURPLE wire to the end going to the starter motor.
GREEN starter kill
After cutting the starter wire connect the GREEN wire to the end going to the key side of the ignition.
RED (2) (+)12V input for relays
Remove the two 30 amp fuses prior to connecting these wires and do not replace them until the satellite has
been plugged into the control module. These wires are the source of current for all the circuits the relay satellite
will energize. They must be connected to a high current source. Since the factory supplies (+) 12V to the key
switch that is used to operate the motor, it is recommended that these wires be connected there.
NOTE: If the factory supplies two separate (+) 12V feeds to the ignition switch, connect one RED
wire of the satellite to each feed at the switch.
ORANGE (+) accessory output
Connect this wire to the accessory wire in the vehicle that powers the climate control system.
PINK (+) ignition output
Connect this wire to the ignition wire in the vehicle.
PINK/WHITE (+) output to second ignition/accessory circuit
Connect this wire to the second ignition or accessory wire in the vehicle (selectable menu feature 2-9).
RED/WHITE 12 V input
If additional current capacity is needed cut this wire, add a fuse adaquate for the circuit to be supplied, and
connect to an additional 12V source.
© 2003 Directed Electronics, Inc. Vista, CA
17