Disassembly Procedure For The Lens - Panasonic Lumix DMC-FX30P Service Manual

8.4. Disassembly Procedure for the
Lens
NOTE: When Disassembling and Assembling for the Lens
1. To minimize the possibility of the CCD being dirt, perform
disassemble and/or assemble under the condition of the
CCD is being mounted.
Disassembling procedures for the CCD unit, refer to item
8.6.
2. Take care that the dust and dirt are not entered into the
lens.
In case of the dust is putted on the lens, blow off them by
airbrush.
3. Do not touch the surface of lens.
4. Use lens cleaning KIT (BK)(VFK1900BK).
5. Apply the grease (VFK1829) to the point where is shown
to" Grease apply" in the figure.
When the grease is applied, use a toothpick and apply
thinly.
8.4.1. Zoom Motor Unit, Master Frange
Unit, Direct/Drive Frame Unit and
1st Lens Frame/2nd Lens Frame
Move Unit
1. Unscrew the 4 screws (A).
2. Remove the zoom motor unit to the indicated by arrow.
3. Move the master frange unit to the indicated by arrow.
4. Turn the drive gear to the indicated by arrow fully.
5. Push the drive unit to the indicated by arrow from lens
side, and then remove the unit of drive/direct frame unit,
1st lens frame/2nd lens frame move unit from the fixed
frame unit.
26