Empire Comfort Systems BVD34FP30(F,L)N-2 Installation Instructions And Owner's Manual page 11

Minimum Framing Dimensions
BVD34
"A" 35 3/4"
(908mm)
"B" 37 3/8"
(949mm)
"C" 14 3/8"
(378mm)
Note:
Attention:
mantel base.
Attention: If a base or mantel is not used and the appliance is
installed directly on carpeting, tile or other combustible material
panel extending the full width and depth of the appliance. The
vertical dimension in Figure 11 must be adjusted when a metal or
wood panel is placed beneath the appliance.
Finishing (Figure 12)
Finish the walls with the material of your choice. Only non-
front.
or modify the air inlet/outlet louvers in any manner.
Provide adequate clearances around air openings into the
combustion chamber.
Caution:
surround (top and sides) are sealed, a 300°F minimum sealant
Only non-combustible material (using 300°F minimum adhesive if
26534-1-0610
INSTALLATION (CONT)
BVD36 BVP42
37 3/4" 37 3/4"
(959mm) (959mm)
39 3/8" 43 3/8"
(1,000mm) (1,102mm)
17 7/8" 17 7/8"
(454mm) (454mm)
Figure 11
Combustible Surround Installation
Louvered Models
Figure 12a
Flush Face Models
Figure 12b
Attention: Cold climate installation recommendation:
When installing this unit against a non-insulated exterior
wall, it is recommended that the outer walls be insulated
to conform to applicable insulation codes.
Page 11