Table of Contents
Advertisement
5.6
LAMP REPLACEMENT
This appliance comes equipped with our "Night Light™". If in the event the lamp
needs to be replaced, follow these instructions.
5.6.1
Turn off all electrical supply.
5.6.2
Remove the glass media and media tray from the fi rebox, see "MEDIA
TRAY INSTALLATION" section.
5.6.3
Unscrew the lens cover. NOTE: Do not handle the lamp with bare
fi ngers, protect with a clean dry cloth.
5.6.4
The lamp will pull straight out of the socket. Replace with Wolf Steel Ltd. parts only (W387-0009), as
lamp and lens are special "high temperature" products.
5.6.5
Replace lens.
5.6.6
Replace glass media and media tray.
5.7
LAMP ASSEMBLY REPLACEMENT
THE FRONT OF THE APPLIANCE BECOMES VERY HOT DURING OPERATION. LET THE APPLIANCE
5.7.1
Remove the glass media and media tray, see "MEDIA TRAY INSTALLA-
TION" section.
5.7.2
Remove the 2 screws holding the lamp assembly shield.
5.7.3
Compress the 3 retainer fi ns and lift out the lamp assembly. Disconnect
the wires.
5.7.4
Replace lamp assembly by aligning key hole and snap into place. Re-
connect the wires.
5.7.5
Re-install the lamp assembly shield.
5.7.6
Re-install media tray and glass media.
NOTE: When removing the media tray make sure the glass media is away
from the center of the screen, exposing the burner, before lifting media tray
out.
When replacing burner, absolutely no glass media can be in cup surrounding the
orifi ce. HINT: If glass falls into cup and surrounds the orifi ce, insert a clean
bag into a vacuum cleaner and vacuum out glass media. Replacement glass media can be ordered
from Wolf Steel Ltd.
5.8
LOGO PLACEMENT
Remove the backing of the logo supplied and place on the glass viewing door, as
indicated.
!
COOL COMPLETELY BEFORE CONDUCTING SERVICE.
WARNING
15
LAMP ASSEMBLY
SHIELD
RETAINER
FINS
KEY HOLE
½"
LOGO
½"
W415-0832 / 09.18.09
Hide quick links:
Advertisement
Table of Contents
