Setting The Clock; Adjusting Temperature - Rinnai REU-VR3237WG Operation & Installation Manual

DELUXE KITCHEN WATER CONTROLLERS

SETTING THE CLOCK

The clock is a 12 hour AM/PM style display. To set the time press the 'Mode'
places the controller into clock setting mode and in the digital monitor the word 'Clock' will be
displayed and the clock digits will flash. If this is the first time the clock has been set the starting time
will be AM 12:00.
Use the or buttons to select the desired time. Holding these buttons down continuously cycles
the digits. When you get close to the time you wish to set, press the button intermittently to avoid going
further than the desired time.
To return to normal mode press the 'Mode'
approximately 10 seconds the controller will return to normal mode.
The time is always displayed regardless of whether the water controller is turned
ON or OFF.
NOTE
The clock may need resetting if power to the water heater unit is disrupted due
to a power failure or if the power is switched off over a prolonged period.

ADJUSTING TEMPERATURE

Simply press the 'hot water temp'
required temperature is displayed on the digital monitor.
To operate the water heater, open any hot water tap. This will
automatically light the burner, providing hot water. The 'In Use'
indicator will illuminate on the water controller.
Once the hot water is running, if the set temperature is either too hot
or cold press the or
reached.
Whilst hot water outlets are open the set temperature may be lowered. However
it cannot then be raised above 43°C. In addition transfer of 'priority' between
NOTE
controllers is not possible. These are safety features.
CHECK WATER TEMPERATURE BEFORE USE.
A parent or carer should always check the temperature before a child is placed
CAUTION
in contact with hot water, see page 5.
Rinnai Australia
button once. If no buttons are pressed for a period of
or buttons until the
buttons until the desired temperature is
14
button twice. This
ON! ON!
COLD COLD
HOT HOT
Operation Manual