Setup Instructions; Product Specifications; Motor Pre-Filtering Assembly - Intex SF20220R Owner's Manual

The sand filter removes suspended particles and does not sanitize your pool.
Pool chemistry is a specialized area and you should consult your local pool
service specialist for details.
Power:
Wattage:
Maximum working pressure:
Effective filtering area:
Maximum Flow Rate:
Recommended filtering media:
Recommended filtering media quantity: 40 to 50 Kg (88 to 110 Lbs)
Limited Warranty:
Pump location and mounting:
• The system must be installed on a solid level and vibration-free base.
• Provide a location protected from the weather, moisture, flooding and
freezing temperature.
• Provide adequate access, space and lighting for routine maintenance.
• Pump motor requires free circulation of air for cooling. Do not install
the pump in a damp or non-ventilated location.
A team of 2 or more people is recommended for setting up this product.
Motor pre-filtering assembly setup:
1. Remove the sand filter and its accessories from the packaging carefully and
inspect for any visible damage. If parts are damaged contact your local
service center listed at the back of this owner's manual.
2. In a counter-clockwise motion unscrew the leaf trap cover (13) from the
pre-filter housing. Take out the basket (15) and filter housing nut (16) (see
drawing 10).
3. Connect the pre-filter housing to the motor water inlet. Note: Align the connector
in the pre-filter housing with the water inlet on the motor (see drawing 11).
SAVE THESE INSTRUCTIONS
(128) MODEL SF20220R SAND FILTER PUMP ENGLISH 7.5" X 10.3" PANTONE 295U 09/08/2009

PRODUCT SPECIFICATIONS

220-240 Volt AC
650 W
3.5 bar (50 psi)
0.13 m
7949 liters/hour (2100 gallons/hour)
Use only No. 20 silica sand. Particle size
range 0.45 to 0.85 mm (0.018 to 0.033
inches). Uniformity Coefficient less than 1.75.
2 Years (see "Limited Warranty")
SETUP INSTRUCTION
10
2 (1.44 ft 2 )
English
128
11
Page 11